Here are some key steps and precautions for maintaining the air filter of the Huaquan generator. I hope the following introduction can provide users with reference.
1、 Regularly clean the air filter of the Huaquan generator
Frequency: maintenance once a week.
method:
Unscrew the gland nut and remove the air filter element.
Use compressed air at 0.2~0.4Mpa to blow out dust particles on the outer surface of the air filter element from the inner cavity of the air filter element.
Clean the dirt on the inner wall of the air filter housing with a clean cloth.
Reinstall the air filter element, paying attention to the tight fit between the sealing ring at the front end of the air filter element and the inner end face of the air filter housing.
For heavy-duty air filters, the housing can be opened directly for cleaning, and the maintenance method is the same as above.
2、 Huaquan generator air filter element replacement
Standard time: The air filter should be replaced every 1500-2000 hours under normal circumstances.
Special environment: In extremely harsh environments such as mines, cotton mills, etc., it is recommended to replace the air filter element every 500 hours.
matters needing attention:
When cleaning or replacing the air filter, the components must be aligned one by one to prevent foreign objects from falling into the intake valve.
When replacing the filter element, attention should be paid to checking whether the new filter element is damaged and whether the gasket is missing. If any defects are found, they should be fully equipped.
When installing the air filter, the intake pipe should be sealed, and special attention should be paid to the sealing of the intake joint sheath.
3、 Daily inspection of air filter for huaquan generator
Inspection content: Regularly check whether the intake expansion pipe is damaged or flattened, and whether the connection port between the expansion pipe and the air filter intake valve is loose or leaking.
Solution: If found, repair and replace in a timely manner.
4、 Other precautions for huaquan generator air filter
Avoid incorrect operation: Do not add oil to the dust collection cup (or dust collector disk), as the oil is prone to splash onto the dust outlet, guide vanes, and other parts, causing them to adsorb dust and ultimately reducing the filtration and separation capacity.
Maintain correct shape: The dust hood and guide vanes should be kept in the correct shape. If there is any collision, they should be reshaped in a timely manner to avoid changing the flow direction of the original design and reducing the filtration effect.
Additional maintenance of filter element:
When cleaning the dust on the paper filter element, use a soft bristled brush to brush away the dust and dirt on the surface of the filter element along the crease direction, and gently tap the end face to remove the dust. When performing the above operation, use a clean cotton cloth or rubber stopper to block both ends of the filter element, and use a compressed air machine or an air pump (with a pressure not exceeding 0.2~0.3MPA to prevent damage to the filter paper) to blow air from inside the filter element to the outside to remove dust adhering to the outer surface of the filter element.
Do not clean the paper filter element with water, diesel, or gasoline, otherwise the pores of the filter element will be blocked, increasing air resistance; At the same time, diesel is easily drawn into the cylinder, causing overspending and "flying" after installation.
When the filter element is found to be damaged, or the upper and lower ends of the filter element are uneven, or the rubber sealing ring is aged, deformed, or damaged, new parts should be replaced.
In summary, the maintenance of the air filter of the Huaquan generator mainly includes regular cleaning, filter element replacement, daily inspection, and other precautions. Following these maintenance steps and precautions can ensure the normal operation of the air filter and extend its service life.
More information on huaquan generator:http://www.wf-fadianji.com/
